Two pack polyamide cured high build epoxy with non-toxic pigments for the protection of steel structures against corrosion in industrial and marine environments. It can be used as a tie-coat on inorganic zinc silicate coatings. Can be overcoated with a wide range of AmourShield products. A self priming surface tolerant epoxy where blast cleaning is neither practical nor economical.
Observe the precautionary notices on the label of the container. A material safety data sheet is available upon request and national or local safety regulations should be followed. This product is intended for use by professional applicators.
As a general rule, avoid skin- and eye contact by wearing overalls, gloves, goggles, mask, etc. Spillage on the skin should immediately be removed by thorough washing with lukewarm water and soap or a suitable industrial cleaner. Eyes should be flushed with fresh water and medical attention sought immediately. Spraying should be carried out under well-ventilated conditions. Avoid inhalation of solvent vapours and paint mist by wearing an air mask.
This product contains flammable materials and should be kept away from sparks and open flames.
Smoking in the area should not be permitted.
The information in this data sheet is provided to the best of our knowledge. However, we have no control over either quality or condition of the substrate and other factors affecting the use and application of this product.
Therefore, we cannot accept any liability whatsoever or howsoever arising from the performance of the product or for any loss or damage arising from the use of this product.We reserve the right to change the product without notice.